Diedrich IR5 Analysis by Doris Garrido
For the second lot of these Madagascan Arabica coffees, I wanted to take a slightly different approach to see how a more measured, controlled profile would express the coffee differently. The lots consist of the same cultivars – Catimor and Red and Yellow Bourbon – and the green aspects were very similar: 10% moisture content and a density of 693 g/L. For this round, my start was a bit less moderate; began with a charge temperature of 400°F and introduced heat earlier. While I usually plan for about 4 minutes of drying phase for Bourbons, my first roast of these Malagasy lots went over 5 minutes. By adding gas earlier, I aimed to shorten the drying phase and stretch the Maillard phase. Towards the end of the roast, I was careful to keep the rate of rise under 20°F per minute as I approached the first crack, primarily to avoid any harsh or bitter notes and to preserve sweetness during development.
I started the roast at 400°F and applied 70% gas within the first 40 seconds, as I noticed the coffee was absorbing heat quickly. The turning point came at 175°F, at which point I pushed the gas to 100% to complete the drying phase. I maintained full gas until 290°F, then dropped to 30%. I opened the airflow completely at 370°F just before the first crack. The roast finished with approximately 5 minutes in drying, 3 minutes in the yellowing phase, and development time of 1 minute and 31 seconds.
In the cup, we found a nice tart acidity with notes of dried citrus, lemongrass, lime, and hints of florals and white tea. It had a pleasant persimmon-like texture, rounded out by milk chocolate and a saffron finish. Slight changes on the roasting approach pay off nicely, shows the potential of dialing the roast even better, I would keep shorting the drying and stretching the rest of the roast.